Absorber setup in software? - Main Forum https://perek.it/community/main-forum/absorber-setup-in-software/ Perek Discussion Board en-US Thu, 11 Jun 2026 13:06:27 +0000 wpForo 60 RE: Absorber setup in software? https://perek.it/community/main-forum/absorber-setup-in-software/#post-116 Mon, 28 Oct 2024 13:55:50 +0000 Hi.

You can find instructions how to set up brake control here:

https://perek.it/help/dyno2-dynamometer-software-setting-up-control-loops/

And here there is a description how to use brake control modes when making runs:

https://perek.it/help/dyno2-dynamometer-software-working-in-run-tab/

Typically, for everyday runs, you use acceleration control mode with acceleration rate around 250 - 500 RPM/s

If you have trouble setting up PID for brake control, contact me on WhatsApp, and I'll help you to set it up via remote desktop.

]]> Main Forum Ronald Perek https://perek.it/community/main-forum/absorber-setup-in-software/#post-116 Absorber setup in software? https://perek.it/community/main-forum/absorber-setup-in-software/#post-115 Mon, 28 Oct 2024 12:58:57 +0000 I have a DC2L and BD2 connected to my MD250. I have looked through the help files but haven't been able to find any sort of instructions for setting up the software for a loaded run. I watched the quick start video for setting up inertia runs but I calibrate alot of turbocharged vehicles and need to use the eddy to load the vehicles to begin making some boost before starting the run. I possibly overlooked one of the help files on it but I have not found any instructions on using the BD2 only wiring it up. Thanks 

]]> Main Forum Holmestuned https://perek.it/community/main-forum/absorber-setup-in-software/#post-115